Hardware – table legs

Home › Forums › DIY Sand Table › Hardware – table legs

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • December 12, 2021 at 4:04 pm #966
    Bram
    Participant

    Hi,

    I’ve finished my sand table, although.. I’m struggling with the table legs. How did you make them for a round table?? Mine sand table is 1000mm (diameter). Can you share yours (any ideas or pictures are welcome)

    thanks

    December 12, 2021 at 5:07 pm #969
    Matt G
    Keymaster

    I built mine out of 2×2 poplar in a “modern” style. Attached to the bottom with press nuts and m6 bolts. This is probably the best picture I have. The table doesn’t tip over in any direction – this has been well tested by my toddler.

  • Author
    Posts
Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.