Any tips for printing the parts?

Home Forums DIY Sand Table Any tips for printing the parts?

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • #881
    bliksem
    Participant

    Any general tips for printing the parts? PLA or PETG for everything? Walls/layers/infill?

    #885
    Matt G
    Keymaster

    I printed everything in PLA except the top arm. I printed that in PETG to give it some flex due to the sagging nature of a large sand area. I also printed everything in 100% infill if it made sense. My original build I didn’t do 100% and noticed some deforming after a while.

    ABS would probably be even better, but I’ve never dialed ABS in on my printer to attempt it.

Viewing 2 posts - 1 through 2 (of 2 total)
  • You must be logged in to reply to this topic.