Sand Table

Setting up and configuring the SandBot

So, you’ve built the Sand Table.. compiled the firmware and have it running on the huzzah32… Now What? I’ll walk through a first time setup to get the bot up and running DISCLAIMER This will only work if you use the exact board, adalogger feather wing and PCB from my original Sand Table post. Don’t …

Setting up and configuring the SandBot Read More »

DIY Kinetic Sand Art Table

56 Comments / Sand Table / By Matt G

NOTE I have created a new post detailing how to configure the sand bot once you have it running. So after reading this, if you have questions, please see my new post. I have also created a forum for Sand Table Questions and Answers here: http://alwaystinkering.com/forums/forum/diy-sand-table/ – I figure this will be easier to read …

DIY Kinetic Sand Art Table Read More »